Operation; Stand Alone Operation; Terminal; Master/Slave-Operation - Futurelight EVO-1 Mode D'emploi

OPERATION

After you connected the effect to the mains, the EVO-1 starts running.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.

Stand Alone operation

In the Stand Alone mode, the EVO-1
can be used without controller. You
can do without a controller as the
EVO-1
microphone,
automatic sound control.
Disconnect the EVO-1 from the
controller and set the DIP-switch 10
and 11 to On (Master-Mode only
DIP-switch 10 to ON).
Put the Dip-switch in the sound
mode and adjust the sensitivity of
the activated sound by turning the
MIC SENSITIVITY-button.

Terminal

Building a serial DMX-chain: At the
last fixture, the DMX-cable has to be
terminated with a 120
the DIP-switch no. 12 of the last
projector to On.

Master/Slave-operation

The master/slave-operation enables
that
synchronized and controlled by one
master-device.
On the rear panel of the EVO-1 you
can find an XLR-jack (DMX Out) and
an XLR-plug (DMX In), which can be
used for connecting several devices.
Choose the device which is to
control the effects. This device then
works as master-device and controls
all other slave-devices, which are to
be connected to the master-device
via a balanced microphone lead.
Connect the DMX OUT-jack with the
DMX IN-plug of the next device.
Set DIP-switch, as in the table listed
under Master Mode, for the master-
device. Set DIP-switch No. 1 to On
for all slave-devices.
28/63
features a
which provides
Ω
resistor. Set
several devices can
51837515_V_1_0.DOC
built-in
be