Operation; Stand Alone-Operation; Master/Slave-Operation - Futurelight LB-12 REB LED-BAR Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

OPERATION

Connect the effect to the mains and switch it on via the POWER-switch.
Attention: After every 10 LB-12 REB LED-BARs, the fixtures must have a renewed connection with the
power mains.

Stand Alone-operation

In the Stand Alone mode, the FUTURELIGHT LB-12 REB LED-BAR can be used without controller. You can
do without a controller as the features a built-in microphone, which provides automatic sound control.
Disconnect the FUTURELIGHT LB-12 REB LED-BAR from the controller.
Please refer to the instructions under Control Board, Main functions, menus Mode, Play and Sound.

Master/Slave-operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LB-12 REB LED-BAR you can find an XLR-jack (DMX Out) and an XLR-plug (DMX
In), which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Please refer to the instructions under Control Board.
27/63
00032426.DOC, Version 1.0

Publicité

Table des Matières
loading

Table des Matières