Replacing The Fuse; Technical Specifications - Futurelight CENTERPIECE-1200 Mode D'emploi

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Sound-control:
Flash-rate:
Number of gobos:
Dimensions:
Weight:
Maximum ambient temperature T a :
Maximum housing temperature T B (steady state):
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Accessory:
OSRAM SharXS HTI 1200W/D7/75 750h
PHILIPS MSI 1200GS 100V/1200W 1000h short
FUTURELIGHT Easy-2 remote control
FUTURELIGHT CP-240 controller
FUTURELIGHT CP-256/64 controller 16bit
FUTURELIGHT CP-512/64 controller 16bit
Wizard-512 USB DMX-Software + Interface
Wizard-1024 USB DMX-Software + Interface
Safety-rope 400x6mm up to 60kg
Safety-rope 900x6mm up to 60kg
Safety-rope 1400x6mm up to 60kg
FUTURELIGHT DES-3 DMX-terminator 3-pin
Please note: Every information is subject to change without prior notice. 05.07.2006 ©
230 V AC, 50 Hz ~
2100 W
19/13
3-pin XLR
via built-in microphone
10 Hz
6 rotating gobos, 1 glass-effect and open
860 x 860 x 465 mm
46 kg
45°C
112°C
0.5 m
0.5 m
F 15 A, 250 V
No. 89302013
No. 89302018
No. 51834011
No. 51834265
No. 51834288
No. 51834295
No. 51860102
No. 51860110
No. 58010450
No. 58010470
No. 58010480
No. 51834001
31/60 51832625_V_1_1.DOC