HumanTechnik Signolux A-26140 Mode D'emploi page 14

Troubleshooting and solutions
Symptoms
When programming a
transmitter, a different icon
lights up...
The red status LED light up
with an alert...
The »signolux« receiver
does not work...
There is no ring tone...
The flash light does not
work...
14 English
Cause
The transmitter you are
trying to programm is
already known to the
receiver.
This indicates a low battery
in the according transmit-
ter.
Ensure that the batteries
have been inserted
correctly.
Check if batteries type
LR14 'C' have been
inserted.
It could be that the trans-
mitter has not yet been pro-
grammed in the »signolux«
receiver.
It could be that the
»signolux« receiver is out
of reach of the transmitter.
switch position 2 (fig. 2)
switch position 0 (fig. 2)
Solutions
See step 7. First the trans-
mitter has to be deleted from
the memory, before it can be
assigned to a new symbol.
Insert a new battery in the
transmitter.
Ensure correct polarity of the
batteries!
Use only alkaline batteries.
Programme it.
Try using the transmitter or
receiver at different location.
Check the position of
the switch (fig. 2) at the
»signolux« receiver.
Ensure that the volume is set
to the lowest setting.
Check the position of
the switch (fig. 2) at the
»signolux« receiver.