HumanTechnik Signolux A-26140 Mode D'emploi page 11

Setting and programming
Figure 2: Receiver, upper side
2. Setting the signal mode
Using the signal mode slide switch (in fig. 2
"0 1 2") you can select the signal mode.
Kindly keep in mind that the symbols are al-
ways displayed with coloured light diodes.
– switch to position 0:
signal tone, no flash,
– switch to position 1:
signal tones and flash
– switch to position 2:
no signal tones, flash only
3. Event icon signification
Figure 3: Event icons, control lamp and vol-
ume control
Each icon is connected to a transmitter
(e.g. doorbell pushbutton) and can be re-
programmed at will.
The icons stand for:
Doorbell 1
Doorbell 2
Telephone
Person call
0 1 2
Colour: Green
Colour: Green
Colour: Orange
Colour: Yellow
Baby
Fire alarm
Flood alarm
Alarm
4. Setting the volume
The front side of the »signolux« receiver is
protected by a screen that can be pushed
upwards after loosening the lock on the top
side of the »signolux«. Behind it you will find
the rotating volume control with which you
can set the volume of the alert tone.
Warning:
This device can generate sounds of up to
90 dB!
In order to protect your hearing, please set a
low volume to begin with and only then ad-
just to the desired volume.
5. Programming signals and assignment
to the icons
Up to 8 transmitters can be assigned to
each icon. This assignment can be adapted
by programming. Kindly keep in mind that a
transmitter can only be programmed if it is
not yet known in the memory of the »si-
gnolux« receiver. If required, you first might
have to delete the transmitter from the memory
(see step 7).
a) Keep the function button »●« (fig. 2)
pressed for some time. The icons light up
in sequence. Let go of the button as soon
as you see the desired icon.
b) Now trigger the alert using your transmit-
ter (e.g. operate the doorbell pushbut-
ton).
c) Wait for about 20 seconds and test the
function.
Colour: White
Colour: Red
Colour: Blue
Colour: Red
English 11