HumanTechnik Signolux A-26140 Mode D'emploi page 12

6. Setting the melody
You can adapt the melody for each icon:
a) First trigger an alert (e.g. operate door-
bell pushbutton).
b) The icon assigned to the transmitter
should light up and the previously cho-
sen melody should be heard.
c) Press and hold the melody setting but-
ton »♫« (fig. 2) for two seconds.
Let go of the button and press it repeat-
edly until you have found the desired
melody (you can choose from 15 melodies).
d) Once the icon ceases to flash, the
selected melody has been assigned.
7. Deleting transmitters from receiver
memory
Do the following if you want to delete a
transmitter from the memory:
a) Keep the function button »●« (fig. 2)
pressed for some time. The icons light up
in sequence. Let go of the key as soon as
you see the desired event icon.
b) Now press the function button »●« and
the melody setting button »♫« (fig. 2),
at the same time, until all icons briefly
light up.
Please note that this will remove all assigned
transmitters from the selected event icon.
12 English
8. Battery level indication
The receiver informs about the state of the
batteries of the receiver as well as the batte-
ries of the transmitters:
- A sufficient battery level of the receiver
is indicated by the red control lamp
flashing every 5 to 6 seconds.
- A low battery level of the receiver is in-
dicated by the red control lamp flashing in
short sequence (once per second).
Please replace the receiver batteries as
soon as possible.
- A low battery level of a transmitter is indi-
cated by the red control lamp shining
together with the event icon of the according
transmitter when it's signal is triggered.
Please replace the batteries of the accor-
ding transmitter as soon as possible.