Supervisory Control Wiring - Briggs & Stratton 071022 Guide D'installation Et D'utilisation

Model 071023
Utility
Connection
Load
Connection
Ground
Terminal
9. Connect generator "UTILITY 240 vAC" terminals to
transfer switch "UTILITY 240 vAC" terminals. Use
minimum #14 AWG conductors.
10. Tighten all wire connections/fasteners to proper torque.
See inside transfer switch enclosure for proper torque
values.

Supervisory Control Wiring

Terminal strip on control module in transfer switch has
four connections for customer use. There are two sets of
"Normally Closed" contacts available. They will be opened
when generator power is required. These can be used to lock
out large loads when powered by generator. Example: air
conditioner, hot water heater, etc..
8
To Utility Meter
To Generator
Generator
Connection
Supervisory
Contacts
Neutral
Terminal
Main Distribution Panel
Neutral
Bus
Ground Bus
Air Conditioner Contactor
A
A
Contactor
B
B
1. Terminals on control module are for installer supplied
contactors to lock out large loads. Example: air
conditioner, electric hot water heater, etc.. Contacts are
connected in series with the contactor control circuit.
2. Tighten all wire connections/fasteners to proper torque.
See inside transfer switch enclosure for proper torque
values.
Main
24 vAC
Neutral
120 vAC
BRIGGSandSTRATTON.COM