Power Wiring Interconnections - Briggs & Stratton 071022 Guide D'installation Et D'utilisation

Power Wiring Interconnections

All wiring must be the proper size, properly supported and
protected by conduit.
Complete the following connections between the transfer
switch, main distribution panel, utility power and generator.
The 100 Amp transfer switch (Model 071022) is depicted
below and the 200 Amp transfer switch (Model 071023) is
depicted on the next page.
WARNING
Low voltage wire cannot be installed in same
conduit as power voltage wiring.
• Failure to follow above warning could cause personal
injury, damage and/or malfunction of equipment.
1. Ensure utility power is turned OFF. Connect utility
Service conductors to line side of transfer switch
service disconnect circuit breaker.
2. Connect utility service Neutral conductor to the transfer
switch "NEUTRAL" terminal.
Model 071022
Utility
Connection
Load
Connection
Ground
Terminal
To Utility Meter
To Generator
3. Connect main breaker panel feeder conductors
to transfer switch terminals marked "LOAD
CONNECTION".
4. Connect main breaker panel Neutral conductor to
transfer switch "NEUTRAL" terminal.
5. Connect main breaker panel Ground conductor to the
transfer switch "GND" terminal.
NOTE: Assure grounding electrode conductor is connected
and bonded per applicable federal, state and local codes,
standards and regulations.
6. Connect generator feeder conductors from the
generator control panel to line side of transfer switch
"GENERATOR" breaker.
7. Connect Neutral conductor from the generator control
panel to the transfer switch "NEUTRAL" terminal.
8. Connect generator Ground conductor from the control
panel to the transfer switch "GND" terminal.
NOTE: Assure generator equipment grounding conductor
is connected per applicable federal, state and local codes,
standards and regulations.
Generator
Connection
Supervisory
Contacts
Neutral
Terminal
Main Distribution Panel
Neutral
Bus
Main
Ground Bus
7