Installation; Unpacking; Mounting Guidelines - Briggs & Stratton 071022 Guide D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation

Unpacking

Delivery Inspection
After removing the carton, carefully inspect the transfer
switch components for any damage that may have occurred
during shipment.
IMPORTANT: If loss or damage is noted at time of delivery,
have the person(s) making delivery note all damage on the
freight bill and affix his signature under the consignor's
memo of loss or damage. If loss or damage is noted after
delivery, contact the carrier for claim procedures. Missing or
damaged parts are not warranted.
Shipment Contents
• Automatic Power Transfer Switch
• Installation and Operator's Manual
Typical
— — — — — — Control Wiring
Hot
Water
Heater
Alternate
Hot
Water
Heater
Emergency Branch Circuits
6
Contactor
Main
Distribution
Panel
Branch Circuits
— — — — — — Control Wiring
Contactor
Emergency
Load
Center
Disconnect Switch

Mounting Guidelines

The Automatic Transfer Switch is enclosed in a NEMA
Type 3R enclosure suitable for indoor/outdoor use.
Guidelines for mounting the Automatic Transfer Switch
include:
• Install the switch on a firm, sturdy supporting structure.
• The switch must be installed with minimum NEMA 3R
hardware for conduit connections.
• To prevent switch contact distortion, level and plumb the
enclosure. This can be done by placing washers between
the switch enclosure and the mounting surface.
• NEvER install the switch where any corrosive
substance might drip onto the enclosure.
• Protect the switch at all times against excessive moisture,
dust, dirt, lint, construction grit and corrosive vapors.
A typical installation of the Automatic Power Transfer Switch
is depicted. An alternative installation of the Automatic Power
Transfer Switch is also depicted. It is best if the transfer
switch is mounted near the utility meter, either inside or
outside. Discuss layout suggestions/changes with the owner
before beginning the system installation process.
Transfer
Switch w/
Service and
Generator
Disconnect
Main
Distribution
Panel
Transfer
Switch
Air
Conditioner
Watt -
Hourmeter
Generator
Air
Conditioner
Disconnect Switch
Watt -
Hourmeter
Branch Circuits
Generator
BRIGGSandSTRATTON.COM

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

071023

Table des Matières