5.2 Data logger functions
The data logger (LOG) allows the automatic and manual storage of series of
measurements with a predefined measuring interval (sampling rate) and up to
4000 measured values. The measuring interval can be set from 1 s to 60 s. The
measured values can be read out later via Bluetooth
5.2.1 Setting the data logger
To set the data logger, press the Bluetooth
on the BENNING CM 10-1 via the rotary switch 6 . The current setting is shown
by a symbol on the digital display K . As soon as the symbol appears, press the
Bluetooth
key 7 repeatedly to select from the following functions:
®
Symbol:
„LOG"
„SAVE"
„CLR"
A selected function will be automatically accepted after 2 seconds and remains
permanently stored.
5.2.2
Automatic storage (LOG)
Set the data logger to automatic storage „LOG" with predefined measuring inter-
val according to section 5.2.1. To enable the data logger, press the Bluetooth
key 7 for 2 seconds until the „
shown on the digital display K . As soon as the measuring interval is shown,
directly press the Bluetooth
10 s, 30 s or 60 s.
After having selected the desired measuring interval, the data logger starts sto-
ring measured values in the internal memory automatically after 2 seconds. If the
data logger is enabled, the symbol "
for 2 seconds to stop the data logger.
Note:
Each start of the data logger „
measured values.
11/ 2019
Function:
Automatic storage with predefined measuring interval
Manual storage by pressing a key
Deleting the internal measured value memory
1
2
Press
LOG
key 7 to set the measuring interval to 1 s, 5 s,
®
LOG
LOG
2 Sec
LOG
2 Sec
Press
>2 Sec
BENNING CM 10–1
key 7 and simultaneously switch
®
3
" symbol and the set measuring interval are
LOG
" is flashing. Press the Bluetooth
" deletes the internal memory and thus all stored
Press
>2 Sec
Wait
2 Sec
for further processing.
®
Press
Press
Press
Press
Press
®
key 7
®
27