Benning CM 10-1 Notice D'emploi page 26

5.1.10 The MIN/ MAX key 9 has two functions:
MAX/MIN function:
The MIN/MAX function automatically records and stores the highest and
the lowest measured value. By pressing the key again, the following
values are displayed: "MAX/MIN" displays the current measured value,
MAX
" " displays the highest value stored and "
value stored. Press the HOLD/ZERO key 5 to pause the MIN/MAX
function. Press the key for approx. 2 seconds to switch back to normal
operating mode.
Voltage indicator function:
Press the key for approx. 2 seconds to enable the voltage indicator func-
tion (VoltSense) for non-contact detection of an alternating field (see
section 8.9).
5.1.11 The MODE key (blue) J has two functions:
Press the MODE key (blue) J to select the secondary or third function
of the rotary switch position.
Press the key for approx. 2 seconds to enable or disable the display
illumination.
5.1.12 The BENNING CM 10-1 switches off automatically after approx. 20 min-
utes (APO, Auto-Power-Off). It switches on again if the rotary switch
is switched on from switch position "OFF" or if a key is pressed. The
switch-off time can be set (see section 5.1.13).
5.1.13 The BENNING CM 10-1 offers individual setting possibilities. To change
a setting, press one of the following keys and simultaneously switch on
the BENNING CM 10-1 from the "OFF" position.
MODE key (blue) J :
HOLD/ZERO key 5 :
HFR 8
5.1.14 Temperature coefficient of the measured value: 0.2 x (stated measuring
accuracy)/ °C < 18 °C or > 28 °C, related to the value for the reference
temperature of 23 °C.
5.1.15 The BENNING CM 10-1 is supplied by means of two 1.5 V batteries (IEC
LR6/ AA).
5.1.16 The battery indication M continuously shows the remaining battery ca-
pacity via a maximum of three segments. When switched on, the device
additionally displays the battery status "Full" (full), "HALF" (half) or "Lo"
(low).
As soon as all segments of the battery symbol have disappeared
and the battery symbol is flashing, the batteries must be re-

placed by new ones immediately in order to prevent danger for
persons caused by incorrect measurements.
5.1.17 The battery life is approximately 300 hours without using the display
illumination and the Bluetooth
5.1.18 Dimensions of the BENNING CM 10-1: (L x W x H) = 254 x 86 x 48 mm
Weight: 490 g with batteries
5.1.19 Current clamp opening: 42 mm
5.1.20 The safety measuring leads supplied are expressly suited for the rated
voltage and the rated current of the BENNING CM 10-1.
5.1.21 The BENNING CM 10-1 supports wireless data transmission via the
Bluetooth
let).
11/ 2019
engine
off
4.0 standard to an Android or IOS device (smartphone/tab-
®
BENNING CM 10–1
trigger engine
point on
Setting the APO time to 5/10/20 min. or switching off
the APO function, "OFF" is shown on the display.
Each time the key is pressed again, the value changes.
Displaying all display symbols
Displaying the firmware version
function (alkaline battery).
®
time
MIN
" displays the lowest

26