Mettler Toledo M400/2(X)H Mode D'emploi page 44

6 Operation On-Site
6.49
B
25.0
B
B 4 6 1 . 5
B 0 . 0
Left: Measurement mode (example), Right: Edit mode (example)
1 Channel information
A: Analog sensor is connected.
B: ISM sensor is connected.
H: Transmitter is in Hold mode. Refer to the Operation Manual of the transmitter.
2 1st line (a), standard configuration
3 2nd line (b), standard configuration
4 3rd line (c), Measurement mode: The screen depends on configuration.
Edit mode: Navigation through the menu or editing parameters
5 4th line (d): Measurement mode: The screen depends on configuration.
Edit mode: Navigation through the menu or editing parameters
6 If a u is displayed, you can use the c or the  key to navigate to it. If you click [ENTER] you will
navigate backwards through the menu (go back one screen).
You can configure the information shown on the display for each line. By default in the
measurement mode no values are shown in the third and in the fourth line of the display.
For configuration refer to the Operation Manual of the transmitter.
en
44
pH
°C
d D LI
d TT M
6.49
B
25.0
B
Channel Select = ISM
Parameter = Auto
pH
°C
u