Use - SOMFY 1875128 Mode D'emploi

If anti-mask function must be enabled:
Recommendations
To avoid detector malfunction while enabling the anti-mask function, there should be no obstacles in the
detector's detection zone within a 1 m radius (such as barbecue, bicycle, etc.).
Frost or snow on the detector can cause false triggering. It is preferable to deactivate the anti-mask
function in winter on frosty or snowy days.
Activate the anti-mask by setting switch 5 to ON position.
You must set switch 1 to OFF position.
Close the detector.
When the cover is closed, the detector goes into learning mode for 1 minute,
which allows it to recognise its environment.
Do not stay in the detector's field during this minute.
You then have 10 minutes to perform a masking test.
Hide the detector for at least 20 seconds, for example, with a cardboard box.
After 20 seconds, the alarm sounds.
Disarm the alarm.
Learning
1 minute
Closing the
cover

Use

The operation of the detector must comply with the choices in the table on page 6.
The tamper protection alarm represented by the pictogram
opening of the detector
pullout of the detector
masking of the detector after 3 minutes.
If the obstacle masking the detector is removed within 3 minutes,
there will be no tamper protection alarm.
These 3 tamper protections operate whether armed or disarmed.
Copyright © 2022 Somfy Activités SA. All rights reserved.
Test
10 minutes
Masking for
20 seconds
Alarm
In operation
Masking for 3 minutes
on your computer appears for:
Wait 11 minutes before
passing in front of the
detector.
Alarm
17