Publicité
Les langues disponibles
Les langues disponibles
TLS2 Setup
Use the worksheet below to record measurements and perform Tank Tilt calculations for each of the tanks.
1.
Stick the tank at the fill riser opening at least three times. Record the average reading in column A of the chart.
2.
Before beginning this step, make sure the Tank Tilt [126] on the screen = 0. Record the probe's Fuel Height (In-Tank
Inventory Function) reading in column B of the chart.
3.
Subtract the value entered in column B from the value entered in column A. Record the result in column C.
4.
Measure the distance in inches (or millimeters if you use Metric Units) between the probe and fill risers. Record the
measurement in column D.
5.
Divide the value in column C by column D to determine the pitch. Record the results in column E.
6.
Measure the distance in inches or millimetres from the probe riser to the center of the tank. Record the distance in
column F.
7.
Multiply column E by column F to determine Tank Tilt (E X F = Tank Tilt Value). Record the value in column G.
A
Stick Gauge
Tank
Avg. Height
No.
@ Fill Riser
1
2
3
4
5
6
*Tank Tilt may be a positive (+) or negative (-) value. If it is a negative value, BE SURE to change the value symbol to minus
(-) when entering a negative Tank Tilt value.
40
Table 3: Calculating Tank Tilt
Tank Tilt Calculation Worksheet
B
C
Probe's Fuel
Height Reading
(Probe Riser)
(A - B = C)
D
E
Distance
Fill to Probe
Pitch
Risers
(C / D = E)
[125-128] Tank Setup Screen 3
F
G
Distance from
Probe Riser to
Tank Tilt*
Center of Tank
(E x F = G)
Publicité
