Märklin Mobile Station Function Keys; Programming With The Märklin Mobile Station; Analogue Mode; Analogue Mode Functions - Roco CV29 Manuel D'utilisation

Märklin Mobile Station Function Keys
Function Function
key
Carriage tail light
Carriage doors corridor side
Carriage doors
compartment side
Conductor's whistle
Conductor's announcement
"All on board please!"
Interior lighting
Programming with the Märklin
1. Press the "ESC" button
2. Rotate to the right "EDIT LOC" --> press OK
3. Rotate 2x to the left to "REG" --> press OK
4. Rotate until the required CV flashes --> press OK
5. Rotate until the required value flashes --> press OK
The locomotive confirms the programming by flashing briefly.
The carriage confirms the programming by the interior lighting flashing and with additional sounds.

Analogue mode functions

The tail light and the interior lighting can always be active or deactivated via CV13/14. No functions can be
switched in analogue mode. The analogue mode is activated via CV29.
When in the DC analogue mode, the tail light is direction-related. The tail lamp is on if the carri-
age is pulled and extinguishes if it is pushed.
As the track voltage is too low at lower speeds, the analogue operation only works above
~7V).
We recommend that the analogue mode be deactivated (CV29) when using a brake section.
8045868921.indd 23
Function Direction-
Typ related
ON/OFF
OPEN/CLOSE
OPEN/CLOSE
ON/OFF
ON/OFF
ON/OFF
Mobile Station
1)

Analogue Mode

Additional
sound





01.02.2010 13:51:38
GB
23