Festo DSMI-25 Notice D'utilisation page 33

DSMI-...
Fitting electrical components
Please note
Leakage currents can damage the measuring system.
S Make sure that the earth connection 7 is connected to earth potential
(mass cable optional either with eye or with male spade).
The cross-sectional area of the cable must be at least 2.5 mm
the cable max. 0.5 m.
S Insert the screw aD with cutting thread
provided into the hole for the earth con-
nection 7.
The electrical contact is then guaranteed
in spite of the anodized layer.
S
Connect the measuring system with the
cable in accordance with the manual for
the SPC... .
The pin assignment is summarized in the following table.
Pin Designation
1 +10 V DC
2 Signal
3 GND
4 Screening
Fig. 29
Festo DSMI-... 0102NH English
2
, the length of
7
Fig. 28
Assignment
3
2 2
aD
1
4 4
33