Festo DSMI-25 Notice D'utilisation page 26

DSMI-...
5 Fitting
Fitting mechanical components
In the case of electronic closed-loop operation of the DSMI-... in conjunction with
the SPC...:
Please note
Special fitting conditions apply to electronic closed-loop operation.
S When fitting, take into account the instructions in the manuals for the SPC... .
The following applies in all cases:
S
Handle the HMPL-... with care so that the
drive shaft is not damaged. This applies in
particular to the following points:
1. Check to see if additional holes are
necessary in the fastening flange of the
DSMI-... .
In the adjacent drawing the shaded parts
mark the areas in which additional holes
can be bored on the DSMI-... (e.g. for
inserting centring pins).
2. Place the DSMI-... so that you can always reach the operating parts.
26
Fig. 7
Fig. 8
Festo DSMI-... 0102NH English