Tilting - lopital Nemo Mode D'emploi

• In order to set its height, the rotating button (1) on the
back of the chair must be undone. Once you have reached
the required height, do the button up again (See figure 14).
• To set the depth of the head / neck support, the handle
(2) is unlocked. Once you have reached the required
height, do the handle up again. The depth setting has
a range of 7 cm.
• The Nemo has a curved head / neck support, allowing the
head of the client to be supported effectively.
Always replace this component on the chair when you have finished using it.
This will avoid the component being lost.

3.5. Tilting

• In order to tilt the Nemo in an ergonomic and responsible manner, the operator
should be standing diagonally behind the Nemo. Grasp the hand grip using your right
hand (1). Using the left hand, hold the frame of the head support firmly (2) (See
figure 15). The chair frame can be tilted by squeezing the
operating handle.
• The Nemo is equipped with a tilting function up to a
maximum of 30 degrees backwards. This function can be
operated by pressing the control handle. The seat element
will then tilt (See figure 16).
• To operate the tilt function you must put the Nemo on the
brake.
• The caregiver can stop the tilting at any time by releasing
the handle.
• To tilt the Nemo forwards the control handle can be used
again (See figure 16).
• During the tilting the arm supports must be folded
downwards and the arms of the client must rest on the
arm supports.
• In addition, during the tilting the client must have placed
his / her feet on the foot support.
• Maintain contact with the client during the tilting.
Before tilting the chair, check to ensure there are no persons or objects in the
vicinity of the chair.
Nemo Shower-toilet chair | Instructions for use | 31
2
1
Figure 14 Head / neck support.
2
1
Figure 15 Tilting frame.
Figure 16 Control handle.