lopital Nemo Mode D'emploi page 29

Figure 5 to 8 Adjustable seating angle.
Figure 9 Locking pins.
Option: Comfort leg supports (Article number 6960 8026)
The comfort leg supports provide the legs with additional support. The comfort leg
supports can be adjusted in length as well as according to the sitting angle. The angle
of the leg supports can be adjusted to 4 positions (See figures 5 to 8). To change the
seating angle, you have to release the locking pin. When you have determined the
correct position, lock the sitting angle of the comfort once again (See figure 9).
Make sure that the locking pin slips in well into one of the 4 holes.
To adjust the length of the leg supports, you have to release the locking pin underneath
by loosen it a bit (See figure 9). Choose the right length for the leg support and tighten
the locking pin again.
Make sure that both the sitting angle and the length of the leg supports are
locked properly as soon as they have to support a load.
Always place these parts on the seat as soon as you finish using them. This
prevents you from looking for the parts.
Setting the angle of the locking pin
Setting the length of the locking pin
Nemo Shower-toilet chair | Instructions for use | 29