Reviewing Test Results - Fora Diamond MINI DM30 Manuel De L'utilisateur

the result is below 10. The decimal point is represented by 1 quick
beep.
Examples:
6.0 mmol/L is announced as 1 long beep (0) – 1 single pause – 6
single beeps (6) – 1 single pause – 1 quick beep (.) – 1 single
pause – 1 long beep (0)
Note:
Information or warnings in the form of symbols displayed
together with the results are not announced acoustically.
Disposing Used Test Strip and Lancet
The device will automatically turn off after the test strip is
removed. To remove the used lancet, remove the lancet from the
lancing device after you have finished testing. Discard your used
strip and lancet properly in a puncture-resistant container.
Important!
The used lancet and test strip may be biohazards. Please consult
your health-care provider for proper disposal which complies with
your local regulations.

Reviewing Test Results

Your device stores the 450 most recent test results along with
respective dates and times in its memory. To enter the device
memory, start with the device switched off.
To review all test results, do the following:
1. Press and release MAIN. The "
2. Press MAIN to review the test results stored in the device. Press
MAIN repeatedly to review other test results stored in the
device. (r) After the last test result, press MAIN again and the
device will be turned off.
To review the day-average test results, do the following:
1. Press and hold MAIN for 3 seconds until the "
appears. Release MAIN and then your 7-day average result
measured in general mode will appear on the display.
2. Press MAIN to review 14, 21, 28, 60 and 90-day average results
stored in each measuring mode in the order of Gen, AC, then
PC. (s)
Note:
• Press and hold MAIN for 5 seconds to exit the memory mode or
leave it without any action for 2 minutes. The device will turn off
automatically.
• If using the device for the first time, the "---" icon will appear
when you recall the test results or review the average result. This
indicates that there is no test result in the memory.
• Control solution results are NOT included in the day average.
Announcement of Memory Result by Universal
Tone
Only the most recent result that was saved can be announced
acoustically. If you press MAIN to turn the meter on, you will first
EN-8
" icon appears on the screen.
" icon