Before Testing; Control Solution Testing; Important - Fora Diamond MINI DM30 Manuel De L'utilisateur

meter will show " ". The meter will then automatically turn off
and the Bluetooth indicator will start blinking, which means the
meter is in the process of pairing with a Bluetooth receiver.
Note:
• You may setup Beep On, Universal Tone On and Beep Off by
press MAIN to change it. (v)
• When Universal Tone is turned on, the meter guides you
through the blood glucose test using beep tones; it also outputs
the result as a series of beeps.
• When Beep is turned off, the alarm function will remain
effective.
• During memory deletion, select 'no' to keep all saved results.
• You may set it up to four reminder alarms.
• To turn off an alarm, find the alarm number by pressing SET,
then press MAIN to toggle On to OFF.
• When the alarm goes off, the device will automatically turn on.
Press MAIN to mute the alarm. If you do not press MAIN, the
device will beep for 2 minutes then switch off.
• If the device is idle for 2 minutes during the setting mode, it will
turn off automatically.

Before Testing

Control Solution Testing

Our Control Solution contains a known amount of glucose that
reacts with test strips and is used to ensure your device and test
strips are working together correctly.
Test strips, control solutions, or sterile lancets may not be included
in the kit (please check the contents on your product box). They
can be purchased separately. Please make sure you have those
items needed for a blood glucose test beforehand.
Do a control solution test when:
you first receive the device.
9 9
you begin using a new vial of test strips.
9 9
you suspect the device or test strips are not working properly.
9 9
your blood glucose test results are not consistent with how
9 9
you feel, or if you think the results are not accurate.
you have dropped or think you may have damaged the device.
9 9
To perform the control solution test, do the following:
1. Insert the test strip into the test slot of the device. Wait for the
device to display the blood drop " ". (e)
2. Press MAIN to mark this test as a control solution test. With "QC"
displayed, the device will store your test result in the memory
under "QC". If you press MAIN again, the "QC" will disappear and
this test is no longer a control solution test. (f)

Important!

When doing the control solution test, you have to mark it so
that the test result will NOT mix with the blood glucose TEST
EN-4