3�4 Delivery Versions; Installation / Commissioning - Renfert Waxlectric I Traduction Du Mode D'emploi D'origine

3.4 Delivery Versions
2156-0000 Waxlectric I, 230 V
2156-1000 Waxlectric I, 120 V
EN
2157-0000 Waxlectric II, 230 V
2157-1000 Waxlectric II, 120 V
3.5 Accessories
2151-1500 Kit of holders Waxlectric
2155-0101 probe, small
2155-0102 probe, medium
2155-0103 probe, large
2155-0104 blade, narrow
2155-0105 blade, wide
2155-0106 blade, chamfer
2155-0101 -0102
4

Installation / Commissioning

⇒ Screw the desired modelling tip into the handpiece (Fig� 1)� Make sure the tip IS NOT skewed or
cross-threaded!
⇒ Connect the handpieces to the control unit (Fig� 2)� The connecting sockets are located on the under-
side of the control unit� On the 2-channel-models, make sure the handpieces are connected to the cor-
rect sockets� The handpieces are marked with coloured rings (red / yellow)� The ring colours can also
be found on the control unit's operating side (Fig� 3)�
The pins must audibly snap into the sockets.
⇒ Feed the handpiece connecting cables through the guide rings towards the front of the unit (Fig� 4)�
⇒ Connect the mains power supply unit to the control unit� The connecting socket is located on the under-
side of the control unit (Fig� 5a)� Feed the power cord out through the opening on the back of the unit
(Fig� 5b)�
⇒ Using the power cord provided, connect the transformer to the mains power supply (Fig� 6)�
Use only the OEM mains power supply unit!
-0103 -0104 -0105
2155-0107 Hollenback, horizontal
2155-0108 Hollenback, vertical
2155-0109 probe, mini, angled
2155-0110 lance blade
2155-0111 blade, beaver-tail
2155-0112 large wax knife
-0106 -0107 -0108 -0109
- 6 -
-0110 -0111 -0112