Preparing Milk Froth And Hot Milk - Siemens EQ.7 Mode D'emploi

Masquer les pouces Voir aussi pour EQ.7:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47
en
de
Drink preparation with milk
Turn the knob 6 to select White coffee
Å
Macchiato
, Cappuccino
Ç
My coffee
.
Place the pipe 10d of the milk frother 10
in the milk container 34.
Swivel the coffee outlet 9 to the right until
it clicks into place.
Place the pre-warmed cup or glass under
the coffee outlet 9 and milk frother 10.
Open the drawer 21 by pressing.
Pour in no more than 2 level measuring
spoons 14 of ground coffee.
Warning: Do not use whole beans or
instant coffee.
Close the drawer 21
Press the start button 8. First milk is
delivered into the cup or glass. After that
the ground coffee is brewed and
dispensed into the cup or glass.
Important: Dried milk residue is difficult to
remove, so clean the milk frother 10 with
lukewarm water immediately after use (see
"Cleaning the milk system").
N.B.: Repeat the procedure for another
coffee / milk drink. If no coffee is taken
within 90 seconds, the brewing chamber
empties automatically to avoid overfilling.
The appliance rinses.
34
SE_TK76_Teil_1_080917.indd 34
Preparing milk froth
Ä
,
and hot milk
Æ
or
!
Risk of burns
The milk frother 10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
Place the pipe 10d of the milk frother 10
in the milk container 34.
Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
Select the required setting
"Milk froth"
the knob 6.
Press the start button 8. Milk froth or hot
milk flows from the outlet of the milk
frother 10 for about 40 or 60 seconds
respectively.
Press the start button 8 again to cut the
process short.
Tip: For extra-hot milk, allow it to be drawn
out of the glass and run through the milk
frother 10 again. Select the "Hot milk"
function again.
Note: When preparing hot milk you may
hear a whistling sound. This is caused by
the milk frother 10 for technical reasons.
Tip: For optimal milk froth quality, use cold
low-fat milk (1.5% fat) if possible.
Important: Dried milk residue is difficult to
remove, so clean the milk frother 10 with
lukewarm water immediately after use (see
"Cleaning the milk system").
È
É
or "Hot milk"
by turning
18.09.2008 08:40:49

Publicité

Table des Matières
loading

Table des Matières