Show Clock; Time Mode; Set Clock; Cup Warmer On (Tk76F09 Only) - Siemens EQ.7 Mode D'emploi

j >
S
3 sec. +
HOW CLOCK
With this function you can set the clock to
show the time in the display 5 during energy
saving mode.
Turn the knob 6 to switch the clock
=
display on YES or off
Note: You must already have set the time
S
as shown in ET CLOCK .
j >
T
3 sec. +
IME MODE
In time mode you can turn the knob 6 to
set the time format to
j >
S
3 sec. +
ET CLOCK
Turn the knob 6 to set the current time,
08:25
e.g.
. The fi gure that can be set is
always backlit; the backlighting switches
automatically between the hours and
minutes.
TK76F09 only
(programmable cup warmer)
j >
C
3 sec. +
UP WARMER ON
With this additional function the cup warmer
19 switches on automatically at a
programmable time, irrespective of whether
the appliance is in "energy saving mode" or
is ready for use.
Note: You must already have set the time
S
under
ET CLOCK
Set the required time by turning the knob
O
6. If FF is selected, the function is
deactivated.
TK76F09 only
(programmable cup warmer)
j >
C
3 sec. +
UP WARMER OFF
Here you can set the time span after which
the cup warmer 19 switches off again
automatically.
Note: The switch-on time must be set under
C
UP WARMER ON
Set the required time by turning the knob
6.
SE_TK76_Teil_1_080917.indd 31
j
=
NO . A time between 5 minutes and 8 hours can
be set.
j
Before a new water fi lter 35 is used, it must
be rinsed.
12 24
H or H .
Note: Rinsing the fi lter simultaneously
activates the setting for the "change fi lter"
display.
The fi lter 35 is no longer effective when the
C
latest after 2 months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance).
>
A
3 sec. +
UTO OFF AFTER
Turn the knob 6 to enter the time span
after which the appliance should
automatically switch to "energy saving
mode" following drink preparation.
>
W
3 sec. +
ATER FILTER
To do this, press the water fi lter 35 fi rmly
into the water tank 11 with the aid of the
measuring spoon 14. Fill the water tank
with water up to the "max" mark.
Turn the knob 6 to select
press the start button 8.
P 0.5
LACE L CONTAINER UNDER MILK
S
FROTHER TART
Place a container with a capacity of 0.5
litres under the milk frother 10.
Press the start button 8. Water will now
fl ow through the fi lter 35 to rinse it.
Next, empty the container. The appliance
is ready to use once more.
HANGE FILTER display appears, or at the
en de
S
TART and
31
18.09.2008 08:40:48