General Maintenance; Oil Repriming; Spare Parts; Ordering - Stanley Masterfix XGRIP N09QI Mode D'emploi

E N G L I S H

3.3. GENERAL MAINTENANCE

General maintenance should be performed after about 300 000 strokes or once every three years. The tool
must be completely disassembled and all seals and worn parts must be replaced. This repair may be carried out
by an authorized technician only or a person trained by the manufacturer or supplier.

3.4. OIL REPRIMING

Connect the tool to the source of compressed air! Press and release the trigger several times.
Disconnect the tool from the source of compressed air! Unscrew pos. 11 with Hex Key no.3. Fill hydraulic
oil (from the supplied bottle with hydraulic oil) into MP53, take extra care to avoid air sucking, air must not be
present in the hydraulic oil. Screw the MP53 tool into pos. B9 and inject the hydraulic oil into the tool. When the
moving part of MP53 tool is released, the redundant oil is returned back to the MP53 tool.

4. SPARE PARTS

4.1. ORDERING

Order the spare parts exlusively from the manufacturer or from your sales agents.
The order must contain tool serial number, part number and number of pieces, name of your company and
precise address, your tax identifi cation number and identifi cation number.

4.2. LIST OF QUICKLY EXPENDABLE PARTS

All types and dimensions of mandrels and anvil .............see chart in paragraph 2.4.
Front nozzle complete ..............................................................D-08650600
Tensile screw ................................................................................O900P01202
Joint sleeve ....................................................................................D-08650400
8