Projectile Hazards; Operating Hazards; Repetitive Motions Hazards - Stanley Masterfix XGRIP N09QI Mode D'emploi

1.2. PROJECTILE HAZARDS

• Disconnect the air supply from the tool before performing any maintenance, attempting to adjust, fi t or
remove a nose assembly or accessories.
• Be aware that failure of the workpiece or accessories, or even of the inserted tool itself can generate high
velocity projectiles.
• Always wear impact-resistant eye protection during operation of the tool. The grade of protection required
should be assessed for each use.
• The risks to others should also be assessed at this time.
• Ensure that the workpiece is securely fi xed.
• Check that the means of protection from ejection of fastener and/or mandrel is in place and is operative.
• DO NOT use the tool without mandrel collector installed.
• Warn against the possible forcible ejection of mandrels from the front of the tool.
• DO NOT operate a tool that is directed towards any person(s).

1.3. OPERATING HAZARDS

• Use of the tool can expose the operator's hands to hazards, including crushing, impacts, cuts and abrasions
and heat. Wear suitable gloves to protect hands.
• Operators and maintenance personnel shall be physically able to handle the bulk, weight and power of the tool.
• Hold the tool correctly; be ready to counteract normal or sudden movements and have both hands available.
• Keep tool handles dry, clean, and free from oil and grease.
• Maintain a balanced body position and secure footing when operating the tool.
• Release the start-and-stop device in the case of an interruption of the air supply.
• Use only lubricants recommended by the manufacturer.
• Contact with hydraulic fl uid should be avoided. To minimise the possibility of rashes, care should be taken to
wash thoroughly if contact occurs.
• Material Safety Data Sheets for all hydraulic oils and lubricants is available on request from your tool supplier.
• Avoid unsuitable postures as it is likely for these positions not to allow counteracting of normal or unex-
pected movement of the tool.
• If the tool is fi xed to a suspension device, make sure that the fi xation is secure.
• Beware of the risk of crushing or pinching if nose equipment is not fi tted.
• DO NOT operate tool with the nose casing removed.
• Adequate clearance is required for the tool operator's hands before proceeding.
• When carrying the tool from place to place keep hands away from the trigger to avoid inadvertent activation.
• DO NOT abuse the tool by dropping or using it as a hammer.
• Care should be taken to ensure that spent mandrels do not create a hazard.
• The mandrel collector must be emptied when approximately half full.

1.4. REPETITIVE MOTIONS HAZARDS

• When using the tool, the operator can experience discomfort in the hands, arms, shoulders, neck or other
parts of the body.
• While using the tool, the operator should adopt a comfortable posture whilst maintaining a secure footing
and avoiding awkward or off -balance postures. The operator should change posture during extended tasks;
this can help avoid discomfort and fatigue.
• If the operator experiences symptoms such as persistent or recurring discomfort, pain, throbbing, aching,
tingling, numbness, burning sensations or stiff ness, these warning signs should not be ignored.
E N G L I S H
3