Black Diamond HELIO 350 Manuel D'installation page 7

5. Completely release the boot and step in again to doublecheck with the 4mm gauge that the boot-heel
distance is correct: the gauge must enter the space without forcing and there must not be any left room in
between boot, gauge and heel. (Pictures 1, 2, 3)
PICTURE 1
3.2.2| ADJUSTMENT: BOOT-BINDING COMPATIBILITY CHECK
• Bellowed touring boots or NTN standard boots with TECH inserts are NOT COMPATIBLE WITH ANY
HELIO TOURING BINDING.
• In walk mode, the contact point in between the boot and the front locking lever must not exceed the
vertical line marked at PICTURE 4 and 5.
PICTURE 4 shows a boot which is COMPATIBLE with the binding: the boot tip gets in touch with the
front lever in a point behind the vertical line marked on the picture.
PICTURE 5 shows a boot which is NOT COMPATIBLE with the binding: the boot tip gets in touch with
the front lever in a point over (even if slightly) the vertical line marked on the picture.
PICTURE 4
The use of a NON-COMPATIBLE boot-binding combination is strictly FORBIDDEN, due to the high
risk of an undesired and/or accidental activation of the front locking lever of the binding that may be
moved from UPHILL WALKING MODE to DOWNHILL SKIING MODE during the uphill walking phase
with a great danger for the User's safety.
PICTURE 2
WARNING! DANGER!
PICTURE 3
PICTURE 5
7