Black Diamond HELIO 350 Manuel D'installation page 14

• Check that the toe part is
in the position shown at
PICTURE 12, ready to
receive the boot, free
from ice, snow or other
debris. If toe is not in the
proper position, manually
press on the front locking
lever in order to reach
the stabilized position
shown at PICTURE 12.
• Move the boot tip towards the toe part, matching the front TECH insert seats with the toe hooking pins
(PICTURE 13). From this position, vertically push on the toe part to step in. (PICTURE 14/15). Rotate a
few times the boot in order to check the proper boot-binding coupling, as shown at PICTURE 15.
PICTURE 13
PICTURE 15
PICTURE 12
PICTURE 14
14