Black Diamond HELIO 350 Manuel D'installation page 12

4.1.2 SKI MODE
In order to set the brake in ski mode starting from
the walk mode, operate as follows (PICT.10):
1) Push the brake pedal all the way down to the ski.
2) Push the side button up to the end of its sliding
range.
3) Release the brake pedal.
4) Release the side button.
5) Proceed with the desired activities.
4.2| UP-HILL/WALKING MODE
• In this modality, the toe part is locked on the boot. This means that in case of fall, avalanche or any
other unluckily situation that can be faced by the user, the release of the boot will be nearly
impossible. This condition represents a GREAT DANGER for the user that could be dragged into an
avalanche by the ski and/or suffer serious injuries in case of fall or accident.
• When the binding is set in up-hill mode, the separation between boot and binding can only occur in
case of heavy material deformations due to an event, external load or particular stress: if this
happens, immediately stop using the product and reach a dealer for a deeper check on the product
and/or to start up a factory service process.
• During the ascent, an accidental impact or any other particular event, may move the front locking
lever of the binding from the uphill walking mode to the downhill skiing mode. This represents a
great danger for the user's safety that may experience an undesired boot release, with consequent
risk of falling or slipping in dangerous conditions: frequently check the correct setting and
stabilization of the front lever of the binding, especially in case of accidental impact.
WARNING! DANGER!
PICTURE 10
12