Black Diamond HELIO 350 Manuel D'installation page 5

3| INSTALLATION, ADJUSMENT AND CALIBRATION
1
3.1| INSTALLATION
These bindings and the connected accessories can be exclusively installed, adjusted or calibrated by a
A "SPECIALIZED TECHNICIAN" is any technician operating in the ski/ski touring business field provided with
1) Is in possession of the original Helio "AUTOMATIC DRILLING JIG" addressed to the installation of the
product and has perfectly understood the entirety of the respective guidebooks.
2) Is in possession of the experience, know-how and skills raising from years of practice in the field of
"TECH" bindings installations, adjustment and calibration.
3) Is in possession of the whole instruments and tools needed to perform a perfect installations,
adjustment and calibration of an Helio ski touring "TECH" binding, including the specific testing
machinery needed to check the real and correct release performance of the binding.
• A wrong setting distance in between boot and binding may create an early and sudden fail of the binding, creating irreparable
The "SPECIALIZED TECHNICIAN" shall: damages to the ski/binding/boot system and/or eliminate/modify the release function in case of fall with consequential
damages to the athlete and third parties.
• Always check that the penetrating lenght of the screws fits the depth of the drilled holes, and anyway with the height of the ski
1) Perfectly install, adjust and calibrate the product and its
in the mounting area; otherwise, use proper screws or contact ATK® at
accessories.
• The binding must be installed only ON NEW SKIS, which present an absolutely flat mounting area and a structural reinforce for
2) Deliver the product to the "Original User" including the the screws tightening and anchoring.
"SEAL OF LIABILITY", still complete and correctly applied
• Each boot has its own substantial geometry: always use the boot used for installation, setup and check of the correct
to the product.
functionality of the binding in combination to the binding itself.
3) Check that the "WARNING STICKER" is properly applied to
one of the two skis in front of the toe piece area.
4) Deliver this "INSTALLATION, USE and MAINTENANCE GUIDEBOOK" to the "Original User".
The installation, adjustment and calibration of a Helio binding is strictly forbidden to any technician that
does not meet the whole 3 above mentioned minimum requirements, because of the greater risks raising
WARNING! DANGER!
TOE PIECE SCREWS MAX TORQUE:
HEEL PIECE SCREWS MAX TORQUE:
WARNING! DANGER!
"SPECIALIZED TECHNICIAN"
the following minimum requirements:
from a wrong installation, adjustment and calibration.
7 N/m
5 N/m
info@atkrace.com .
5