Technical Features - Bartscher 286.626 Mode D'emploi

Scaldapatate elettrici

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Model

K7ESP05TT Electric chip scuttle ½ unit top

K7ESP05VV Electric chip scuttle ½ unit on cabinet

K7ESP05PP Electric chip scuttle ½ unit on cabinet with door

WARNINGS

General

x Read the instructions carefully before installation, use and maintenance of the appliance.

x The installation has to be carried out by qualified personnel following the manufacturer's

instructions in the specific manual.

x The appliance has to be used by trained personnel only and for the intended use only, that is to

say to keep fried and/or already heated food warm.

x In the event of breakdown or malfunctioning, switch off the appliance and call the after sales

assistance from an authorized centre only.

x Use original spare parts only; otherwise no liability is accepted by the manufacturer.

x The appliance must not be washed with high pressure water sprays, neither must the openings or

air fumes on heat inlets/outlets be blocked.

ATTENTION! The manufacturer declines any liability for damage caused by wrong

installation, tampering, making unauthorized changes, improper use, poor maintenance,

installation of non-original spare parts, not observing local norms, incorrect use or not

observing the instructions in this booklet.

For the installer

x The functioning of the appliance has to be explained and shown to the user. After ensuring that

everything is clear, the instruction booklet has to be handed over to the user.

The following instructions for set up and functioning refer to electric appliances. The data plate (fig.

3, p.3) with all the information to refer to regarding the appliance, is situated inside the right or left

side of the control panel, depending on the model.

The appliances have been checked in accordance with the European directives below.

CEE 2006/95

- Low Tension (LVD)

CEE 2004/108

- Electromagnetic Compatibility (EMC)

98/37/EC

- Appliance to the directives

and the particular reference norms.

Declaration of compliance

(Table 1) TECHNICAL FEATURES

Description