Technical Features - Bartscher K6ECP05TT Mode D'emploi

 The user must be informed that any building modification or restructuring that may in any way
modify the air supply necessary for combustion, makes it necessary to carry out another check of
the functionality of the appliance.
The data plate (fig. 2 – p. 3) with all the information to refer to regarding the appliance is situated
inside the right or left side of the control panel, depending on the model.
The appliances have been checked in accordance with the European norms below.
2006/95/EC - Low Tension (LVD)
2004/108/EEC - Electromagnetic Compatibility (EMC)
2006/42/EC - Machinery directive
2011/65/UE - Rohs
And the particular reference norms.
Declaration of compliance
The manufacturer declares that the appliances of their production are compliant with the above
mentioned EEC norms and requires that installation be done observing the norms in force,
particularly regarding the system for letting out fumes and air exchange.
Electric pasta cooker
Sturdy structure in steel placed on four feet which make it possible to regulate the height. The outer
finishing is stainless steel.
The cooking vat is provided with an energy regulator, which enables the user to regulate the output
from maximum to minimum.
Safety is ensured by means of a manually-reactivating thermostat placed on the back side of the
appliance.
The cooking vat is entirely made of stainless steel, resistant to salted water and starch.
Heating is achieved by means of sheath-protected heating elements resistant to salted water.
Place (fig. 3 – p. 3)
It is advisable to install the appliance in a well ventilated room or under an extractor hood. The
appliance may be installed as a single unit or together with others. In both cases, if it is installed
near a wall of inflammable material, a minimum distance of 50 mm from the side and back walls
must be observed. In the event that it is not possible to observe this distance, protective measures
must be taken (e.g. use of sheets of refractory material) which ensure that the temperature of the
walls is within the established safety limits.

TECHNICAL FEATURES

DESCRIPTION OF APPLIANCES
PROVISIONS FOR INSTALLATION
Pag. 23/44