Dry Ironing; Vertical Steaming - Russell Hobbs 14733 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

You may have to press it 2 or 3 times to pump water through the system.
SHOT OF STEAM:
This works with dry or steam ironing, as long as there's
water in the reservoir, and the temperature is above
Check that there's water in the reservoir.
Check that the temperature control is at
Lift the iron off the fabric.
Press the
button.
You may have to press it 2 or 3 times to pump water through the system.
Leave 4 seconds between shots, to let the temperature build up.

DRY IRONING:

If you're going to be dry ironing for 20 minutes or
more, empty the reservoir first, to avoid spontaneous
bursts of steam.
Move the steam control to
Wait till the thermostat light goes out, then start
ironing

VERTICAL STEAMING:

Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
Check that there's adequate ventilation behind the fabric, otherwise moisture
may build up, causing mildew.
Check that there's nothing behind the fabric that may be damaged by the steam.
Check that pockets, turn-ups, and cuffs are empty.
Check that there's water in the reservoir.
Turn the temperature control to max, move the steam
control to
.
Hold the iron close to (but not touching) the fabric.
button (you're using the "shot of steam"
Press the
function vertically).
or higher.
.
7
.

Publicité

Table des Matières
loading

Table des Matières