Dry Ironing; Steam Ironing - Russell Hobbs RHI101 Mode D'emploi

FIRST TIME IRONING
1. Remove any protective films or stickers from the soleplate and the cabinet, if any.
2. Unwind and straighten the power cord.
3. Fill the water tank, as described in "How to fill water".
4. Connect the appliance to a suitable mains supply outlet.
5. Turn the Temperature Dial on the iron unit in a clockwise direction to the maximum
position, pilot light glows.
6. Pilot Light goes off when the required temperature is reached.
7. Move the steam control dial to
holes in the soleplate.
8. Begin first time ironing with an old towel.
9. When the water tank is empty and there is no more steam produced, the
preparation work is complete. The iron is now ready for proper use.
SPRAYING
1. This function can be used any time and does not affect
any setting.
Fill the water tank as described in "How to Fill Water".
2.
3. Aim the nozzle to the garment.
4. Press the Spray Button.
Note: It may be necessary to press the spray button a few times to start this function.

DRY IRONING

1. Unwind and straighten the power cord.
2. Connect the appliance to a suitable mains supply outlet.
3. Turn the Temperature Dial on the iron in a clockwise direction, select '
-
label.
4. The Pilot light glows indicating the iron is switched on.
5. The Pilot Light goes off when the required temperature for the iron is reached.
6. The appliance is now ready for use.
7. When finished with your ironing, turn the iron to the off position/MIN and
disconnect the power cord from the mains supply outlet.
8. When the appliance cools down completely, store it in a safe place.
9. Do not wrap the cord around the iron.

STEAM IRONING

1. Unwind and straighten the power cord.
2. Fill the water tank as described in "How to Fill Water"
3. Connect the appliance to a suitable mains supply outlet.
4. Turn the Temperature Dial in clockwise direction to '
setting or to 'Max' setting. (For optimum steam quality, do not use 1
dot or 2 dots setting for steam ironing); The Pilot light glows, indicating
the iron is switched on.
5. The Pilot light goes off when the required temperature is reached.
position, steam starts coming out from the
-3) according to the recommendation of the garment
(
' (3 dots)
-1),