After Use; Self Clean - Russell Hobbs 14733 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

You may have to press it 2 or 3 times to pump water through the system.
Leave 4 seconds between shots, to let the temperature build up.

AFTER USE:

Turn the temperature control to ●, move the steam control to
Unplug the iron.
Lift the bottom of the water inlet cover to open it.
Hold the iron over a sink, turn it upside down, and
drain the water from the reservoir.
Caution the water may be hot
Place the iron on its heel.
Leave it to cool down completely.
When it's cold, wipe off any moisture, and close the water inlet cover.
Store the iron on its heel, to avoid corrosion and damage to the soleplate.

SELF CLEAN:

To prevent scale building up, use the self clean function regularly, at least
monthly in normal water areas, more often in hard water areas.
You'll need a basin or a large bowl to catch the water coming out of the soleplate.
Fill the reservoir to the max mark.
Turn the temperature control to max, move the steam control to
Place the iron on its heel.
Put the plug into the power socket, and wait till
the thermostat light goes out.
Now hold the iron over the basin or bowl, with the
soleplate down (#9).
Move the steam control to
gently move the iron to and fro, over the basin or
bowl.
Caution keep clear of the escaping water and steam
Water and steam will wash scale and dust through the soleplate, and into the
sink.
, hold it there, and
8
.
.

Publicité

Table des Matières
loading

Table des Matières