Steam Ironing - Russell Hobbs 23300 Mode D'emploi

Label marking
l hot – cotton, linen
i do not iron
If the instructions on the fabric label differ from this guide, follow the instructions on the label.
FILLING
You may use the iron with tap-water, but if you live in a hard water area, you should use distilled
water (not chemically descaled or softened water). If you buy distilled water, check that it's
suitable for use in irons.
1. Open the water inlet cover.
2. Pour slowly, to let the air in the reservoir escape, otherwise you'll cause an air lock and the
water will overflow.
3. Don't fill past max, or water will escape during use.
4. Wipe up any spillage.
HEATING YOUR IRON
Your iron is heated by placing it onto the stand. The smart status light will show you when you
need to reheat your iron and when it is ready to use. The smart status light operates as follows:
Smart Status Light
Steady red
Flashing green
Flashing red
Flashing red, 3 beeps
Slowly pulsing red
Important Note:
Between ironing tasks always put the iron back onto the stand. This ensures the most efficient
heating and gives you the best performance from your iron.
1. Set the temperature control to the setting you require.
2. Put the iron onto the stand and plug the stand into the power socket (switch the socket on,
if it's switchable). The smart status light will light up red and your iron will start to heat up.
3. When the smart status light flashes green your iron is ready to use.

STEAM IRONING

1. To steam iron, set the temperature control to l or higher.
2. Set the steam control to the setting you want, n = no steam, h= high steam.
3. When the smart status light flashes green your iron is ready to use.
SPRAY
Water spotting affects some fabrics. Test this out first on a hidden part of the fabric.
1. Lift the iron off the fabric.
2. Aim the spray nozzle at the fabric.
3. Press the s button – you may have to press it 2 or 3 times to pump water through the
system.
SHOT OF STEAM
1. Steam is available when the temperature control is at l or above.
2. Lift the iron off the fabric.
3. Press the hbutton.
4. Leave 4 seconds between shots, to let the temperature build up.
Remarks
Your iron is heating up
Your iron is ready to use
Your iron needs reheating but you can carry on ironing for a little
longer
Your iron must be reheated as soon as possible
Auto shut-off activated
4
Dot setting
•••/max
-