Unpacking; Disposal Of The Packaging; Setup; Setup Location Requirements - CASO DESIGN VC 250 Mode D'emploi

3.4 Unpacking

Carefully remove the packaging material and unit from the carton.

3.5 Disposal of the packaging

Caso believes in the importance of recycling and has selected packaging materials
that not only protect your unit from damage during transit, but can be recycled to
minimize any ecological impact. Recycling the packaging materials preserves raw
materials and reduces waste. Take any packaging materials that are no longer
required to a recycling collection point for proper disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of a
guarantee claim.

3.6 Setup

3.6.1

Setup location requirements

In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfill the following prerequisites:

The device must be set up on a solid, even, horizontal surface capable of supporting the
vacuum sealer and any items to be vacuum-sealed.

Select a setup location where children cannot reach the hot sealing strip of the device.

Do not set up the unit in a hot or damp environment or near flammable material.

To operate correctly, the unit requires sufficient air flow. Leave at least 10 centimeters (4
inches) of space on all sides when setting up the unit.

Do not move the vacuum sealer when it is in operation.

The electrical outlet must be easily accessible so that the plug can be quickly disconnected
in the case of an emergency.

The setup of this unit in non-stationary locations (e.g., boats, airplanes, motor homes) must
be carried out by a qualified electrician, provided they guarantee the prerequisites for the
safe use of the unit.

3.7 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:

Before plugging in the unit, compare the voltage and frequency data on the vacuum
sealer's rating plate (found on the bottom of the unit) with that of your electrical network.
This data must be compatible. If in doubt consult a qualified electrician.

The use of a multi-plug outlet adapter is not recommended due to fire danger.

Inspect the power cord for damage and ensure it doesn't run under the unit or over hot or
sharp surfaces.

The electrical outlet must be protected by a 16A safety cut-out switch.
9