Cleaning Plastic Parts; Disposing Of The Product; Storing The Product - Chicco GoFit PLUS Mode D'emploi

approved by the manufacturer, since it is an integral part of
the child car seat and, therefore, one of its safety elements.
WARNING! To ensure the safety of the child car seat, never
use it without its fabric cover.

CLEANING PLASTIC PARTS

Clean the plastic parts only with a soft cloth soaked in wa-
ter or a neutral detergent. Never use abrasive detergents
or solvents. The moving parts of the child car seat must
not be lubricated.
CHECKING THE CONDITION OF THE COMPONENTS
It is recommended to regularly check the condition of the
following components to make sure they are not damaged
or worn:
• Fabric cover: check that the padding does not come out
from the seams. Check the condition of the seams: they
must always be intact and undamaged.
• Plastic parts: check that the plastic parts are not worn out,
damaged or faded.
WARNING! If the child car seat is damaged, deformed or
worn out, it must be replaced as its original safety features
will have been compromised.

STORING THE PRODUCT

When it is not fitted in the car, it is recommended to store the
child car seat in a dry place, away from sources of heat and to
protect it from dust, humidity and direct sunlight.

DISPOSING OF THE PRODUCT

When the child car seat no longer complies with the original
safety standards, stop using it and dispose of it at an appro-
priate collection point. Always dispose of the child car seat
following the guidance and regulations set out in the coun-
try of use.
WARRANTY
The product is guaranteed against any conformity defect in
normal conditions of use as provid ed for by the instructions.
The warranty shall not therefore apply in the case of damage
caused by improper use, wear or accidental events. For the
duration of the warranty on conformity defects please refer
to the specific provisions of applicable national laws in the
country of pur chase, where appropriate.
26