Amana ARG7300 Serie Mode D'emploi page 10

Converting Surface Burners for Use with
LP\Propane
1. Remove 4 burner control knobs from range.
• Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside. See Pivot Point in figure.
• Gas valve and orifice hood are visible after burner
control panel is removed.
A—Burner Control Knob
B—Pivot Point
C—Burner Control Panel
D—Screw
4. While facing range front, turn orifice hoods
counterclockwise 1½ to 2 turns or until snug.
• Use ½ inch open end or 90° offset open end
wrench.
• Do not over tighten orifice hoods. If orifice hoods
are over tightened, gas supply can be cutoff or
orifice hoods can strip.
A—Orifice Hood
B—Air Shutter
5. Reassemble Burner control panel after adjusting air
shutter.
• See Adjusting Surface Burner Flame section.
Converting Oven Burner for Use with LP\Propane
1. Remove storage drawer.
• Removing Storage Drawer section.
2. Locate and remove 2 screws attaching Z-shaped
cover plate.
• Cover plate located in center, rear of storage drawer
cavity.
• Removing cover plate exposes oven burner orifice
and air shutter.
C
A—Air Shutter Screw
B—Orifice Hood
C—Air Shutter
3. Turn orifice hood clockwise until snug.
• Do not over tighten orifice hoods. Orifice hoods can
strip.
4. Replace cover plate and storage drawer.
10
A
B