Sigma EF-630 Manuel D'instructions page 21

Caution!!
After the power switch is turned to ON, if the
is indicated in the Status area, or if the distance indication in
the Status area is blinking, the flash head is not correctly set to
the front direction.
LIMITS OF CONTINUOUS SHOOTING
To prevent overheating of the flashgun's circuitry, do not use
your flash unit for at least 10 minutes after continuously firing
the flash for the number of exposures shown in the table below.
Mode
TTL, M(1/1, 1/2)
M(1/4, 1/8)
M(1/16～1/32)
MULTI
Caution!!
In case the icon appears on the display, the amount of light
will be limited to prevent overheating of the flashgun's circuitry.
Refrain from using the flashgun until the icon
BASIC STEPS OF SETTING
This section describes the basics of the settings. With EF-630,
most settings can be conducted easily by the following steps.
Caution!!
When the power switch is at the [ ] (lock) position, the settings
cannot be changed. Be sure to set to [ON] to change the
settings.
mark
Number of Flash Exposures
20 Continuous Flash Shots
25 Continuous Flash Shots
40 Continuous Flash Shots
10 Cycle
disappears.
Switchover between the Main screen and the Setup menu by
using the button. (When the power is set to [ON],
always start from the Main screen.)
Main Screen
Changes the Flash mode and
sets the details of each Flash
mode.
① Status area
② Flash mode area
③ Mode details area
BASIC OPERATIONS ON MAIN SCREEN
SELECTING FLASH MODE
Select the Flash mode area by
using the buttons and change
the Flash mode by using the
buttons or the dial.
SETTING DETAILS OF FLASH
MODE
Select Mode details area by using
the buttons and change the
setting values by using the
buttons or the dial.
Setup Menu
Adds the optional functions of
flash shooting and sets the
basic conditions of the flash.
④ Tab area
⑤ Sub menu
21