Explanation Display Functions - Tunturi S25 Manuel De L'utilisateur

English
Adjusting the handlebar
The handlebar can be adjusted according to
the height and the exercise position of the user.
- Loosen the handlebar adjustment knob.
- Move the handlebar to the required position.
- Tighten the handlebar adjustment knob.
Adjusting resistance (Fig. E)
- Adjust the pedalling resistance by the control
lever.
- When lever is up, resistance is at minimum.
- When lever is down, resistance is at
maximum
NOTE
Emergency break
To apply the emergency brake, press down the
control lever fully.
Replacing the batteries (Fig. G-2)
The console is equipped with 2 AAA batteries
at the rear of the console.
- Remove the console.
- Remove the old batteries.
- Insert the new batteries. Make sure that
batteries match the (+) and (-) polarity
markings.
- Mount the console.
Console (fig. G-1)
CAUTION
• Keep the console away from direct
sunlight.
• Dry the surface of the console when it is
covered with drops of sweat.
• Do not lean on the console.
• Only touch the display with the tip of your
finger. Make sure that your nails or sharp
objects do not touch the display.
NOTE
• The console switches to standby mode
when the equipment is not used for 4
minutes.
All manuals and user guides at all-guides.com

Explanation Display functions

Scan
- Automatically scan through each mode in
sequence every 5 seconds.
Time
- Without setting the target value, time will
count up.
- When setting the target value, time will count
down from your target time to 0 and alarm
will sound.
- Display range: 00:00 ~ 99:59.
Speed
- Displays current training speed.
- Range 0.0 ~ 99.9 / Units: KM/H.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, Speed
will display "0".
RPM
- Display the rotations per minute
- Range: "15 ~ 999".
- Without any signal being transmitted into the
monitor for 4 seconds during workout, RPM
will display "0"
Distance (Dist)
- Without setting the target value, distance will
count up.
- When setting the target value, distance will
count down from your target distance to 0
with an alarm.
- Range 0.0 ~ 999.9 / Units: KM.
Calories
- Without setting the target value, calorie will
count up.
- When setting the target value, calories will
count down from your target calorie to 0 with
an alarm.
- Range: 0 ~ 9999 / Units: K.Cal.
NOTE
• This data is a rough guide for comparison
of different exercise sessions which cannot
be used in medical treatment
Pulse (T.H.R.)
- Current pulse will display after 6 seconds
when detected by the console.
16