Activating The Repeater Function - Waldmann TALK EnOcean Manuel D'utilisation

ENG
Setting the Advanced Group Control
NOTES:
This function must be set for all lumi-
ƒ
naires of the desired group.
The swarm control must be activated
ƒ
for all luminaires of the desired group.
Fig. 31: DIP switch position for the Advanced
Group Control function
X Disconnect the luminaire from the
power supply.
X Set the DIP switches no. 1 and no. 2 to
the "ON" position, see Fig. 31.
X Set the DIP switch no. 3 to the "OFF"
position.
NOTE: The position of the DIP switch
no. 4 is irrelevant for this function.
X Reconnect the light to the power sup-
ply.
X Perform a teach-in for external receiv-
ers, see chapter 11.1 "Teach-in of exter-
nal receivers" , page 50.
X If the external function is not yet acti-
vated, activate the external function
for the luminaire for which the external
receiver was taught in, see chapter 11.3
"Activating and deactivating the exter-
nal function" , page 51.
54

Activating the repeater function

12. Activating the repeater
function
If the range of one module is no longer
sufficient, another module can be used as
repeater.
All telegrams, including those from external
products, will be received and forwarded.
NOTE: Use the repeater function only if the
range of a module is in the limiting range.
Keep the number of repeaters low, as the
performance may drop due to increased
traffic.
Fig. 32: DIP switch position for the repeater
function
X Disconnect the luminaire from the
power supply.
X Set the DIP switch no. 4 to the "ON"
position.
NOTE: The position of the other DIP
switches is irrelevant for this function.
X Reconnect the light to the power sup-
ply.