Waldmann TALK EnOcean Manuel D'utilisation page 52

ENG
Functions for a certain luminaire
Simple Single Control
ƒ
External receivers are switched on
when the sensors of a certain luminaire
detect presence, and the brightness of
daylight is insufficient. This is the case
when the luminaire is in the work light-
ing mode or the service lighting mode
is active.
Advanced Single Control
ƒ
External receivers are switched on
when the sensor of a certain luminaire
detects presence, even if the luminaire
is not lit.
Functions for any luminaire in a group
Simple Group Control
ƒ
External receivers are switched on
when the sensors of any luminaire in a
group detect presence, and the bright-
ness of daylight is insufficient. This is
the case when the luminaire is in the
work lighting mode or the service light-
ing mode is active.
Advanced Group Control
ƒ
External receivers are switched on
when the sensor of any luminaire in
a group detects presence, even if the
luminaire is not lit.
52
Connecting external receivers
Setting the Simple Single Control
NOTE: In the module as delivered, this
function is preset.
Fig. 28: DIP switch position for the Simple
Single Control function
X Disconnect the luminaire from the
power supply.
X Set the DIP switches no. 1, no. 2 and
no. 3 to the "OFF" position, see Fig. 28.
NOTE: The position of the DIP switch
no. 4 is irrelevant for this function.
X Reconnect the light to the power sup-
ply.
X Perform a teach-in for external receiv-
ers, see chapter 11.1 "Teach-in of exter-
nal receivers" , page 50.
X If the external function is not yet acti-
vated, activate the external function,
see chapter 11.3 "Activating and deacti-
vating the external function" , page 51.