Mounting; Mounting The Module In A Lavigo Or Lavigo Vtl Free-Standing Luminaire - Waldmann TALK EnOcean Manuel D'utilisation

ENG
5.

Mounting

WARNING
Risk of injury caused by electric shock.
X Disconnect the luminaire from the
power supply.
5.1 Mounting the module in a
LAVIGO or LAVIGO VTL free-
standing luminaire
NOTE: If the module has already been
mounted ex works, you can immediately
start configuring the swarm control, see
chapter 7 "Configuring the swarm con-
trol" , page 42. You can identify a mounted
module by a part of the antenna protruding
from the luminaire head at the top.
B
Fig. 1: Removing the cover.
X Remove the cover A.
X To make a hole for the antenna of the
module, break the plate B out of the
cover.
X With LAVIGO VTL: Loosen the screw
which is used for mounting the TIME
module.
38
C
Fig. 2: Module in a LAVIGO luminaire head.
NOTE: When mounting the module,
ensure correct position of the antenna,
as otherwise the cover on the lumi-
naire head can no longer be mounted
correctly.
X Insert the module C into the unused
area in the luminaire head, see Fig. 2.
With LAVIGO VTL: Move the lug of the
TALK module under the lug of the TIME
A
module.
X Fasten the module using the delivered
short screws. With LAVIGO VTL: Use
the delivered long screw on one side
of the module to screw down the two
modules TALK and TIME.
X Mount the cover on the luminaire head.
In doing so, pass the antenna of the
module through the hole in the cover.
Mounting