Table des Matières
Publicité
Page 6 of 19
FITTING INSTRUCTIONS
•
REMOVE SEAT USING KEY.
•
DISCONNECT THE TAIL LIGHT ELECTRICAL CONNECTOR AS ARROWED IN PICTURE 1.
•
FROM BELOW, REMOVE THE FOUR BOLTS ARROWED IN PICTURE 2 USING A 10mm
SOCKET AND A WRENCH. GENTLY WITHDRAW THE OEM LICENCE PLATE BRACKET AND THE
WIRING.
•
ON THE OEM LICENCE PLATE BRACKET, REMOVE THE 6 SCREWS ARROWED IN PICTURE 3
USING A T15 TORX KEY.
•
GENTLY SPLIT THE OEM LICENCE PLATE BRACKET IN A HALF. PLEASE NOTE THE
ORIENTATION OF THE CONNECTORS AS THEY NEED TO BE RECONNECTED AT A LATER
STAGE. DISCONNECT ALL ELECTRICAL CONNECTORS (INDICATORS AND LICENCE PLATE
ILLUMINATOR) FROM THE SUB-HARNESS.
•
REMOVE THE INDICATOR NUTS AS ARROWED IN PICTURE 4 USING A 13MM SPANNER.
REMOVE THE INDICATORS AND ITS WIRING FROM THE OEM LICENCE PLATE BRACKET.
PLEASE NOTE THE ORIENTATION LOCATION OF THE INDICATORS.
•
REMOVE THE SUB-HARNESS COMPLETELY FROM THE OEM LICENCE PLATE BRACKET AS
SHOWN IN PICTURE 5.
•
FROM THE KIT, TAKE THE R&G LICENCE PLATE BRACKET (ITEM 1) AND ATTACH R&G
LICENCE PLATE ILLUMINATOR (ITEM 9) THROUGH THE 3 IN-LINE HOLES AS ARROWED IN
PICTURE 6. SECURE THE LICENCE PLATE ILLUMINATOR USING THE WASHERS AND NUTS
PROVIDED IN THE KIT.
•
FIT LICENCE PLATE SHROUD USING A SMALL AMOUNT OF SUPER-GLUE OVER THE LICENCE
PLATE ILLUMINATOR (ITEM 9) (SHOWN IN PICTURE 6).
•
PLACE THE LICENCE PLATE COVER BRACKET (ITEM 2) INTO POSITION AND SECURE IN
POSITION USING THE M4 BOLTS, WASHERS AND NUTS (ITEMS 6, 7 and 8) AS SHOWN IN
PICTURES 7, 8 AND 9.STICK THE TWO SELF ADHESIVE FOAM PADS (ITEM 10) INTO
POSITION AS SHOWN IN PICTURE 10.
•
FROM THE KIT, TAKE THE FOUR M6 x 20mm BOLTS (ITEM 4), M6 WASHERS (ITEM 5) AND
8mm SPACERS (ITEM 3). INSERT THEM INTO THE FOUR MOUNTING HOLES AS SHOWN IN
PICTURE 11.
•
FIT THE OEM INDICATORS AS ORIGINAL AND SECURE WITH OEM NUTS REMOVED EARLIER.
•
IF USING R&G MINI OR AERO INDICATORS:
1. FIT THE INDICATORS ONTO THE LICENCE PLATE BRACKET (ITEM 1) AND
2. FROM THE KIT, TAKE THE WIRING COVERS (ITEM 14) AND FEED THE
3. USE THE RUBBER GROMMETS (ITEM 15) TO BLANK THE REMAINING HOLES.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
TIGHTEN THE NUT.
INDICATOR WIRE THROUGH AS SHOWN ABOVE, THEN FEED THE HEAT SHRINK
TUBE (ITEM 16) OVER THE WIRES AND OVER THE TAIL OF THE WIRING COVER
AND GENTLY HEAT TO CONTRACT TO THE COVER TAIL AND WIRES.
R&G
www.rg-racing.com
LP0202
Email:
info@rg-racing.com
Publicité
Table des Matières
