Fitting Instructions - R&G BLGFK0001 Mode D'emploi

Page 3 of 7
• To fit the R&G Brake Lever Guard, you will need to remove the original bar-end using the specific
tools to your bike. Place the M6 washer (item 9) over the M6 cap-head bolt (item 8), then slide
through the brake lever guard (item 1) so the washer sits against the flat surface within the
mounting bore.
If bars are between 13-18mm internal diameter:
• Place the smallest (unthreaded) cone spacer (item 4) over the exposed thread (so it sits against
the lever guard).
• Place the smallest expander (item 6) over the exposed thread (so it sits against the smallest
tapered spacer just fitted).
• Place the smallest tapered nut (item 2) onto the thread and engage until it locates in the expander
just fitted.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
EXPLODED ASSEMBLY VIEW

FITTING INSTRUCTIONS

R&G Racing
www.rg-racing.com Email:
BLGFK0001
info@rg-racing.com