NSK Ti-Max X-SG20L Mode D'emploi page 8

CAUTION
Always keep the bur/drill shank clean. Dirt or debris in the chuck could cause poor bur/drill concentricity or low chuck
retention force.
Always insert the bur/drill all the way into the chuck. If insertion is insufficient, premature failure of the bearings or
accidental release of the bur may occur.
Do not exceed Max. Bur/Drill Length shown in "10. Specifications".
Always follow the instructions provided by the bur/drill manufacturer.
Do not exceed the bur/drill speed recommended by the bur/drill manufacturer.
Should the handpiece function abnormally during use, stop using the handpiece immediately and contact your Authorized
NSK Dealer.
Do not use the following fluids to wipe, immerse or clean the product; strong/super acid water, strong acid/alkaline
chemicals, chlorine-containing solutions, solvents such as benzine or thinner.
The handpiece is delivered in a non-sterile condition and must be autoclaved prior to use.
Perform regular function and maintenance checks. (Refer to "9. Periodical Maintenance Checks")
If the handpiece has not been used for a long period, rotate the handpiece and check for noise, vibration and overheating
before use.
6