NSK Ti-Max X-SG20L Mode D'emploi page 16

CAUTION
Do not use bur/drills with problems listed below as the bur/drill may break, seize up or disengage from the chuck.
- Bent, deformed, worn, rusted, broken, deficient bur/drill.
- Bur/drill which is cracked on the edge or axis.
- Non-ISO(EN ISO) standard, or tampered bur/drill.
Do not use bur/drills other than specified in "10. Specifications" as such bur/drills may be accidentally released or break
during rotation.
Always keep the bur/drill shank clean. Dirt or debris in the chuck could cause poor bur/drill concentricity or low chuck
retention force.
Always insert the bur/drill all the way into the chuck. If insertion is insufficient, premature failure of the bearings or accidental
release of the bur may occur.
Do not exceed Max. Bur/Drill Length shown in "10. Specifications".
Do not exceed the bur/drill speed recommended by the bur/drill manufacturer.
Do not mount or remove the bur/drill until the motor has completely stopped.
Do not apply excess pressure to the bur as it may break or bend or become difficult to remove.
14