NSK Ti-Max X-SG20L Mode D'emploi page 7

CAUTION
When operating the product always consider the safety of the patient.
Users are responsible for the operational control, maintenance and continual inspection of this product.
Prior to clinical use, inspect the handpiece. Check for vibration, noise and overheating. If any abnormalities are found, stop
using the handpiece immediately and contact your Authorized NSK Dealer. (Refer to "7. Checking the Handpiece Before
Each Use")
Do not disassemble or alter the handpiece except as recommended by NSK in this Operation Manual.
Do not allow any impact on to the product. Do not drop the product.
Operators and all others in the area must wear eye protection and a mask when operating this handpiece.
Only X-SG20L / SG20 can use drill.
Do not use bur/drills with problems listed below as the bur/drill may break, seize up or disengage from the chuck.
- Bent, deformed, worn, rusted, broken, deficient bur/drill.
- Bur/drill which is cracked on the edge or axis.
- Non-ISO(EN ISO) standard, or tampered bur/drill.
Do not use bur/drills other than specified in "10. Specifications" as such bur/drills may be accidentally released or break
during rotation.
5