baltur COMIST 180 DSPNM Mode D'emploi page 11

APPLICATION OF THE BURNER TO BOILER for COMIST 250 - 300
1 Boiler plate
2 Flange with insulating materials
3 Seam with insulating materials
4 Burner securing flange
5 Stud bolts, washers and nuts for fastening to the boiler
6 Nuts screws and washers to fasten flange to the sleeve
COMBUSTION HEAD ASSEMBLY
To put in place insulation flange 2, which must be positio-
ned between the burner and the plate of boiler 1, the end
of the combustion head must first be removed.
a) Adjust position of connector flange 4 by loosening
screws 6 so that the combustion head penetrates into
the combustion chamber the amount recommended
by the generator's manufacturer.
b) Position seal insulation 3 on the tube unit.
c) Fasten the combustion head assembly to the boiler 1 using the stud bolts, washers and the nuts provided 5.
d) With suitable material, completely seal the space between the tube unit of the burner and the hole on the refractory plate inside the
boiler door.
DRAWING SHOWING THE GAS TRAIN ASSEMBLY
All manuals and user guides at all-guides.com
7 / 30
0006080118_200811
E
N
G
L
I
S
H
N° 8797